Specialpromo
 
 
Facebook    Twitter    YouTube
 
 

  Home > Linecard > Quatro Air Technologies >

AB030 Brush and Pad replacement kit
AB030 Brush and Pad replacement kit
Images are for reference only
See Product Specifications

  
Our Price: $169.50
Mfg Part Number: AB030


Availability: Available
Product Code: AB030_Q122
Qty :

Description
 
Brush and Pad replacement kit for Quatro Air Technologies Extraction system

One AB030 kit contain the 4 brushes and the pads for one complete service

Compatible Unit
SPH400

SERVICE NOTE: Please note that your system is equipped with carbon brushes and they need to be replaced at a maximum of every 500 hours of operation. Periodic Inspection of motor brushes is essential. Brushes should be changed at no less than 1/4" of brush material remaining. Failure to do so may result in damaged motors that will not be covered under warranty.

Replacement Instructions

DISCONNECT POWER PRIOR TO ACCESSING TOP LID OR MOTOR SECTION
Open lid of SPH unit and remove filters.
Once filters are removed turn unit upside down to reveal the bottom of the unit.
Remove the seven outer screws holding the base plate to the unit (the 4 corner screws are the outer screw of each wheel assembly, do not remove the inner screw of the wheel)
You will now see the the motor as well as the brushes installed.
Using a screwdriver, unscrew the 2 screws holding down each of 2 gold colored brush casings until the brush is freed, do not unscrew completely.
Lift gold colored tab and lift/pull out each brush.
Replace each brush onto turbine motor, screwing down the phillips screws over tab just sufficiently to hold the brush in place.
Do not overtighten. Replace base of unit and install the 7 screws. Flip unit right side up and reinstall filters in the same sequence that they were removed Replace and latch lid.

Average Rating: Average Rating: 4 of 5 4 of 5 Total Reviews: 1 Write a review.

  0 of 0 people found the following review helpful:
 
4 of 5 April 19, 2024
Reviewer: John Pedranti from Hyannis, MA United States  
It did take some time to get the items shipped due to payment requests/confirmation. Hopefully next time payment should go through smoother and items shipped quicker.

Was this review helpful to you?


Browse for more products in the same category as this item:

Linecard > Quatro Air Technologies
Soldering & Rework
Soldering & Rework > Fume Extraction
Soldering & Rework > Fume Extraction > Filters


Super Cold 134 Plus, 400 grams (14 oz) aerosol
10PK 90DEGREE 4"OFFSET ROUND
Steel Wire Cutter, packaged in clamshell
Super Cold 134 Plus, 400 grams (14 oz) aerosol
10PK 90DEGREE 4"OFFSET ROUND
Steel Wire Cutter, packaged in clamshell
$31.35
$175.55
$41.25